An Repairs To Double Glazed Windows Success Story You'll Never Believe

Can Double Glazed Windows Be Repaired?

If you've recently had double glazing installed in your home and are beginning to show signs of failure, you might be wondering if they can be fixed.

Depending on what the issue is and when you bought them from You may be eligible to receive your double glazing back under warranty.

Broken Panes

If a window's glass is damaged or cracked air can flow through more easily. This can reduce the effectiveness of the window as an insulation barrier and also against the elements. Depending on the season, this can cause warm or cold air to escape or enter your home, which can increase heating and cooling costs.

If the crack in your double glazing isn't very deep, it may be possible to simply apply a strong-hold tape. This is only temporary fix, and will just stop the crack from getting more severe. To ensure the most effective results, www.Repairmywindowsanddoors.Co.uk a professional window repair company is required to fix any damaged glass in double-glazed windows.

It is risky and challenging to replace windows on your own. If the crack is large and difficult to remove Try applying strips of masking tap in a crisscrossing pattern. If the crack is not too large it is possible to make use of a razor to cut the glass from the frame. Wear gloves and a mask while cutting the glass. Once the pane is free you must place it flat on several layers of newspaper to keep any pieces that fall.

To install a new pane you will need to purchase replacement glass and set up the frame. To ensure that the new pane fits properly take a measurement of the opening of the window frame and subtract between 1/16 and 1/8 inches on both sides. Cut your replacement glass at a local hardware store or glass shop according to this measurement. If you have wooden frames, you can purchase glaziers points from a hardware store to place them on the outside of your new pane. Be sure to position the points in a manner that allows for expansion and contraction, while keeping the putty in a flat position against the glass.

Once your new pane is set and you are happy with it, apply a thick layer of your chosen glazing compound using the help of a putty knife. Use a linseed-oil-based putty like Sarco or a cheaper product like Dap glazing compound. If you have any gaps between your new pane and the frame then fill them in using your chosen compound. Make sure you smooth the compound so that it is even and level all around your pane.

Water Leaks

Water leaks around a window's frame or sash are a typical issue. This occurs when the sealant on windows has worn out and needs to be replaced. Water leaks around the window can cause damage to the drywall or plaster and cause damp walls.

A double-glazed window that is of good quality has a gasket that is firmly compressed when the sash is closed. Any water that hits this area should be drained away through the weep holes at the bottom of the frame. Sometimes, however, the weep holes are blocked by a build-up of dirt and debris or the weather stripping around the window could need to be replaced.

Another source of water leaks is the lintel which supports the brick over the window. The installers who built the house may not have understood that this lintel should be allowed to drain properly or they could have merely clad it with concrete leaving an opening where rainwater could be able to enter and collect around the window causing dampness in the wall or wood rot. The installers should have bent the fascia boards over the window to ensure that the water is directed properly. This will prevent water from entering the building through these gaps.